VersiCharge™ SG Commissioning and Troubleshooting Guide
SECTION 12
Halo Operation
12.1 Halo states
Halo indicator on VersiCharge indicates the status of the charging session.
State mame
Power Available
Ready to Charge
Charging
Pause
Delay Timer
Remote
12.2 Halo deactivation
Deactivate to lower power consumption of your device during normal operation. Note: Deactivation of the
Halo will prevent the Halo from illuminating in all states, except the Fault state.
To de/re-activate the Halo:
• Unplug the EV from the chargers and place in the coupler holster.
• Verify that the VersiCharge is in the Power Available state by ensuring that only the Power Available
indicator and, if applicable, the Wi-Fi Status indicator LED's are lit.
• Press and hold both the Pause and the Delay Timer buttons simultaneously for 5 seconds. The Halo will
blink green three times, and then fade to off.
40
Description
240V or 208V Power Present
EV detected, waiting for charging command from EV
Charging EV
Operation paused
Operation awaiting delay timer
System is controlled via remote control interface
Halo status indicator
Off
Green - Solid
Green - Fading in and out
Off
Off
Depends on charging or fault state