Checking The Wanderguard Blue Tag Battery Level; Tag Scan Using The Detector - Stanley Healthcare WanderGuard BLUE User Manual

Checking the WanderGuard BLUE Tag Battery
Level
To check WanderGuard BLUE Tag Battery Level:
1. Turn on WanderGuard BLUE Detector by short-clicking the power
button.
2. Place the Tag within the LF range of the Detector (less than 0.5 meter).
The Detector constantly sends LF messages.
3. The Detector displays the Tag Battery level by flashing the Tag Battery
LED for one second after receiving the BLE message from the Tag.
4. When the Detector is in proximity to an activated Tag that has a good
battery, the LF and Battery LED flash Green every 2 seconds.
If multiple Tags send BLE messages, the Battery LED will be Ivory color.
Note
Best Practice: It is recommended to have the Tag battery checked at
least once a week.

Tag Scan Using the Detector

To run a scan for Tags using the Detector:
1. Turn on WanderGuard BLUE Detector by short clicking the power
button.
2. Place the Detector close to the Tag (less than 0.5m).
3. The Detector constantly sends LF messages so Tags in the vicinity will be
transmitting BLE messages.
4. Run Scan in the Mobile Application.
5. View Tag properties in the WanderGuard BLUE Manager's Scan results
page.
User and Deployment Guide
73