Table of Contents
Advertisement
Obsolete Equipment
Obsolete Equipment
As equipment is placed on the obsolete list (quite often due to the rapidly changing nature of the
RF environment and the improvements in computer hardware), LXE makes every effort to
support, service and repair the equipment until it is no longer repairable/serviceable. The
information contained in this document relating to obsolete devices has been made available as a
courtesy to LXE's customers.
Please contact your LXE customer support representative for assistance with these units and for
replacement equipment and software.
The 2335 and MX1 are obsolete as of December 2005. The 2330 is obsolete as of May 2000.
Software/Hardware Upgrades Required for the 2330 only
The following upgrades are available for 2330's that will be used with the docking cradle.
• A 2330 without an "M" in the product serial number must be returned to LXE for upgrade
before using the 2330 in the Docking Cradle. The serial number is located on the LXE
product identification tag on the back of the 2330.
• Rev. C CPU upgrade to the 2330 is performed at LXE.
• RetroFit Kit, LXE part number 154873-0001, upgrade to the 2330 is performed at LXE.
Please contact LXE Customer Support at 770-449-0154 to determine if your 2330 requires
upgrading.
Retainer Clip for 2330 Required
Each 2330 that is to be placed in the cradle must have a Retainer installed.
Note:
Turn the mobile device off, if necessary, and place the mobile device face down on a flat surface.
Position the retaining strap bracket on the mobile device as shown below.
Insert the flat head screw and tighten securely.
E-EQ-MX1DKRG-B
If the 2330 has a hand strap installed already, you do not need to perform this step.
The Screw part number is: 711205-1716
The Retainer part number is: 153852-0001
MX1 Cradle Reference Guide
7
Advertisement
Table of Contents
