Table of Contents
Advertisement
26
Step 2 - Connect the Cradle to the Table Bracket
1. If the mobile device is in the storage cradle, remove it from the cradle and place in a safe
location.
2. Turn the Power Module, if installed in the cradle, off and remove all cables from the Power
Module.
3. Place the cradle in front of the table bracket, aligning the upper screw holes in the back of the
cradle with the upper screw holes in the table bracket.
4. Insert the flat washer, lock washer and pan head screws in the cradle screw holes and torque
the Pan Head Screws to 8±1 in/lb (.90±.11 N/m).
5. The cradle is now ready to use. If a Power Module is installed in the cradle, reattach all cables
and turn the Power Module on.
MX1 Cradle Reference Guide
Flat Washer
Lock Washer
Rubber
Foot
With Power Module
Pan
Head
Screw
Rubber
Foot
Without Power Module
Putting it all Together
Flat Washer
Lock Washer
Pan
Head
Screw
E-EQ-MX1DKRG-B
Advertisement
Table of Contents
