Table of Contents
Advertisement
30
Attach the Passive Bracket
1. If the mobile device is in the storage cradle, remove it from the cradle and place in a safe
location.
2. Place the passive cradle face up on a flat surface.
3. Insert a Flat Washer, Lock Washer and Pan Head Screw into each of four holes at the front of
the cradle.
4. Attach the Passive Bracket to the cradle.
5. Torque the Pan Head Screws to 8±1 in/lb (.90±.11 N/m). Now you are ready to attach the
Left and Right Brackets.
Attach the Left and Right Brackets
1. Place the passive cradle face down on a flat surface.
2. Put the Left and Right Brackets on the cradle, aligning the screw holes in the cradle with the
screw holes in the brackets.
3. Insert a Flat Washer, Lock Washer and Pan Head Screw into each hole.
6. Torque the Pan Head Screws to 8±1 in/lb (.90±.11 N/m).
Cradle With Power/Communications Module
Equipment Needed: Torque wrench capable of torquing to 8±1 in/lb (.90±.11 N/m) .
1. If the mobile device is in the storage cradle, remove it from the cradle and place in a safe
location.
2. Turn the Power Module off and remove all cables from the Power Module.
3. Place the cradle face down on a flat surface.
4. Put the Left and Right Brackets on the cradle, aligning the screw holes in the cradle with the
screw holes in the brackets.
5. Insert a Flat Washer, Lock Washer and Pan Head Screw into each hole.
6. Torque the Pan Head Screws to 8±1 in/lb (.90±.11 N/m).
MX1 Cradle Reference Guide
Flat Washer
Lock Washer
Pan Head
Screw
Spacer
Putting it all Together
E-EQ-MX1DKRG-B
Advertisement
Table of Contents
