D-CUT MD-230 Operation Manual

Flooring cutter

Advertisement

OPERATION MANUAL
D-CUT Flooring Cutter MD-230
www.dcutproducts.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MD-230 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for D-CUT MD-230

  • Page 1 OPERATION MANUAL D-CUT Flooring Cutter MD-230 www.dcutproducts.com...
  • Page 2 6. Make sure tool is secure. Operate only on a firm substrate or solid stand. 7. Use the right tool. Do not force the D-Cut Multi-flooring Cutter or use it for a job for which it was not designed; use only on approved materials.
  • Page 3 CUTTING AND C Installation 1 Install the table to the cutter base with provided screws and bolts as shown. Warning: Do not put your fingers against the sharp edge of the blade at any time. Installation 2 Then insert the handle into the handle base as show and tighten provided screw.
  • Page 4 Changing the Blade Use the provided Allan wrench to remove the five screws, then hold the blade by each end and carefully move the blade out of blade holder. Note: the flat side of the blade facing the table. Warning: Do not put your fingers against the sharp edge of the blade at any time.
  • Page 5 PARTS LIST...
  • Page 6 PARTS LIST Parts Q’ty Parts Q’ty Screw M6 × 12 Right ABS Handle Washer Bolt M4 × 30 Φ6 Rubber Feet Left ABS Handle Guide Bar Hex Bolt M8 × 55 Nut M10 Hex Bolt M8 × 50 Sleeve Main Base Nut M5 Screw M4 ×...

Table of Contents