Advertisement
Quick Links
Advertisement
Related Manuals for D-CUT TC-330
Summary of Contents for D-CUT TC-330
- Page 1 OPERATION MANUAL D-CUT Flooring / Trim Cutter TC-330 www.dcutproducts.com...
- Page 2 7. Make sure tool is secure. Operate only on a firm substrate or solid stand. 8. Use the right tool. Do not force the D-Cut Multi-flooring Cutter or use it for a job for which it was not designed; use only on approved materials.
- Page 3 CUTTING AND C Installation of the Cutter(1) Install the handle assembly to the cutter base as shown. Warning: Do not put your fingers against the sharp edge of the blade at any time. Straight Cut Insert the floor plank between the cutting blade and the base, flush with the guide bar on the working table, hold the plank...
- Page 4 Bevel Cut (1) Make a straight cut on a workpiece to your measurement and then pull the knob as pointed by an arrow, adjust the cutter head to your desired angle. Pull out the handle from the base to change the handle position on the cutting head.
- Page 5 Changing the Nylon Bar Use provided Allen wrench to Loosen the five screws, then carefully move nylon bar out of the nylon bar holder. Note: the flat side of the blade should face the working table. Warning: Do not put your fingers against the sharp edge of the blade at any time.
- Page 6 Explosive View...
- Page 7 Explosive View...
- Page 8 Explosive View Parts Q’ty Parts Q’ty Wheel Screw M6X20 Screw Handle Base Sleeve Bolt M12X95 Washer 10 Screw M8 B Screw M8 X14 Screw M8 C Screw M5 X 12 Handle A Rectangular Tube Handle Base Nylon Bar Nut M4 Nylon Bar Holder left ABS handle Washer 5...