Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for D-CUT MD-460
Summary of Contents for D-CUT MD-460
- Page 1 OPERATION MANUAL D-CUT Flooring Cutter MD-460 www.dcutproducts.com...
- Page 2 7. Make sure tool is secure. Operate only on a firm substrate or solid stand. 8. Use the right tool. Do not force the D-Cut Multi-flooring Cutter or use it for a job for which it was not designed; use only on approved materials.
- Page 3 CUTTING AND C Installation Install the table to the cutter base with provided screws and bolts as shown. Then insert the handle into the handle base as show and tighten provided screw. Warning: Do not put your fingers against the sharp edge of the blade at any time.
- Page 4 Changing the Blade Use the provided Allan wrench to remove the seven screws, then hold the blade by each end and carefully move the blade out of blade holder. Note: the flat side of the blade facing the table. Warning: Do not put your fingers against the sharp edge of the blade at any time.
- Page 5 PARTS LIST...
- Page 6 PARTS LIST Parts Q’ty Parts Q’ty Screw M6 × 12 Right ABS Handle Washer Bolt M4 × 30 Φ6 Rubber Feet Left ABS Handle Guide Bar Hex Bolt M8 × 55 Nut M10 Hex Bolt M8 × 50 Screw M5 × 8 Main Base Sleeve Screw M4 ×...
Need help?
Do you have a question about the MD-460 and is the answer not in the manual?
Questions and answers