Advertisement
Quick Links
Advertisement
Related Manuals for D-CUT RC-200
Summary of Contents for D-CUT RC-200
- Page 1 OPERATION MANUAL Vinyl Wall-base Cutter RC-200 www.dcutproducts.com...
- Page 2 7. Make sure tool is secure. Operate only on a firm substrate or solid stand. 8. Use the right tool. Do not force the D-Cut Multi-flooring Cutter or use it for a job for which it was not designed; use only on approved materials.
- Page 3 Handle Assembly Insert the handle to the handle base and use the provided screw/ washer /spring washer to secure as shown. Straight Cut Place the work-piece flush with either side of the guide bar on the working table and align the blade to the mark on the work-piece where needs to be cut.
- Page 4 Bevel Cut (2) Place the work-piece flush with either side of the guide bar on the working table and align the blade to the mark on the work-piece where needs to be cut. Then press the handle down to complete the cut.
- Page 5 Changing the Nylon Base Use provided Allan wrench to take off total 6 screws to remove the working table , then take off the four screws as shown to replace the nylon board when it is necessary. When the cutter is not in use, you need to keep the blade in a close position for the safety.
-
Page 6: Explosive View
Explosive View... -
Page 7: Part List
Part List Parts Q’ty Parts Q’ty Screw M5 x 8 Screw M8x 16 Front Working Table Cup head Screw M6x 10 Frame A Blade Washerφ8x 1.5 Cutter Base Working Table Connection Lock Nut M8 Screw M6 x 20 Wing Nut Spring Washer φ6 x 1.3 Rear Wheel Washer φ8 x 2...