V-RTU2000 Series
Veesta - Remote Terminal Unit
Technical Specification Manual
Chapter 14 - Dimensions
14.1
General
14.2
VR-2101A Sub rack
All rights reserved. Passing on and copying of this document, use and communication of its contents not permitted without written authorization.
In V-RTU2000 Series system, to have best configuration and
adaptation from very small RTU system up to very large scale
system, we have some type of sub racks that you can use each type
based on configuration. In this chapter you can see more about
dimensions of sub racks for V-RTU2000 Series.
This sub rack is suitable for a feeder terminal unit application. There
is one slot of Power Supply module and one slot of CPU card. 5 slots
are available for any type of IO cards. In the right side of sub rack
there is a space for mounting VP-2760 an intelligent power meter
module.
Dimension of sub rack is 3U x 42T x 185mm (H*W*D). Each "U" unit
is 1.75" inches (~44.5mm) vertically dimension and each "T" unit is
0.2" inches (~5.1mm) horizontally dimension of sub rack. All
dimensions in the picture bellow have +1 mm tolerance.
The Cut Out size is 228
Figure 14-1: VR-2101A Sub Rack detail Dimension
Chapter 14 - Dimensions
+1
+1
x133
mm.
Page 86 of 90