Veesta World V-RTU2000 Series Technical Information page 82

V-RTU2000 Series
Veesta - Remote Terminal Unit
Technical Specification Manual
All rights reserved. Passing on and copying of this document, use and communication of its contents not permitted without written authorization.
 Mode 2: Independent 4xPT Measurement Mode, it is for
measuring 4 independent AC voltage inputs. Each PT individually
metering voltage and wired to the back plane of Card. The
metering is individual so PT input can be phase to phase or
phase to neutral. For setup this mode you must jumper only R82,
R83, R84, R85 in front of ACV Card. (It is special mode and not
available now)
 Complex Mode 1 & Mode 2: One 3xPhase within 2 individual
Measurement Mode, it is possible to have Mode 1 and Mode 2 in
one card. For this Group 1 or Group 2 can configure as freely to
Mode 1 or Mode 2. For example If you jumper R86 and R87 and
R84 and R85, it means that for group 1 you have one 3xPhase
AC circuit voltage measurement and for place of Group 2 you can
measure 2 independent AC voltage. (It is special mode and not
available now)
Chapter 13 - Wiring & Cabling
Page 82 of 90