Performance And Characteristics - Smartgen HGM9510 User Manual

3 PERFORMANCE AND CHARACTERISTICS


With ARM-based 32-bit SCM, high integration of hardware and more reliable;

480x272 LCD with backlight, multilingual interface (including English, Chinese or other
languages) which can be chosen at the site, making commissioning convenient for factory
personnel;

Improved LCD wear-resistance and scratch resistance due to hard screen acrylic;

Silicon panel and pushbuttons for better operation in high/low temperature environment;

RS485 communication port enable remote control, remote measuring, remote communication
via ModBus protocol.

Fitted with CANBUS port and can communicate with J1939 genset. Not only can you
monitoring frequently-used data (such as water temperature, oil pressure, engine speed, fuel
consumption and so on) of ECU machine, but also control start, stop, raising speed and
speed droop via CANBUS port.

Suitable for 3-phase 4-wire, 3-phase 3-wire, single phase 2-wire, and 2-phase 3-wire systems
with voltage 120/240V and frequency 50/60Hz;

Collects and shows 3-phase voltage, current, power parameter and frequency of Bus/mains.

For Bus, controller has loss of phase and phase sequence wrong detection functions; For
generator, controller has over voltage, under voltage, over frequency, under frequency, over
current, over power, reverse power, loss of phase, phase sequence wrong detection
functions;

Synchronization parameters ： Voltage Difference Between Bus and Mains, Frequency
Difference Between Bus and Mains, Phase Difference Between Bus and mains;

Multiple running modes in auto state: with load running, off load running, demand parallel
running;

Ramp on and ramp off function;

3 fixed sensors (temperature, oil pressure and liquid level);

2 configurable sensors can be set as sensor of temperature, oil pressure or fuel level;

More kinds of curves of temperature, oil pressure, fuel level can be used directly and users
can define the sensor curves by themselves；

Precision measure and display parameters about Engine,
Temp. (WT)
Oil pressure (OP)
Fuel level (FL)
Speed (SPD)
Battery Voltage (VB)
Charger Voltage (VD)
Hour count (HC) can accumulate Max. 65535 hours.
HGM9510 Genset Parallel Unit
HGM9510 GENSET PARALLEL UNIT
° C/° F both be displayed
kPa/Psi/Bar all be displayed
%(unit)
r/min(unit)
V (unit)
V (unit)
ISSUE 2013-08-06 Version 1.1 Page 7 of 65