Table of Contents
Advertisement
16.15 SCANIA
It is suitable for S6 engine control module. Engine type is DC9, DC12, and DC16.
Terminals of controller
Fuel relay output
Start relay output
CAN GND
CAN(H)
CAN(L)
Engine type: Scania
16.16 VOLVO EDC3
Suitable engine control mode is TAD1240, TAD1241, and TAD1242.
Terminals of controller
Fuel relay output
Start relay output
programmable output 1
Terminals of controller
CAN GND
CAN(H)
CAN(L)
Engine type: Volvo
NOTE: When this engine type is selected, preheating time should be set to at least 3 seconds.
16.17 VOLVO EDC4
Suitable engine types are TD520, TAD520 (optional), TD720, TAD720 (optional), TAD721,
TAD722, and TAD732.
Terminals of controller
Fuel relay output
Start relay output
CAN GND
CAN(H)
CAN(L)
Engine type: VolvoEDC4
HGM9510 Genset Parallel Unit
HGM9510 GENSET PARALLEL UNIT
B1 connector
3
-
-
9
10
"Stand alone" connector
H
E
P
"Data bus" connector
-
1
2
Connector
Expanded 30A relay, and
relay
offers
voltage for terminal14.
Fuse is 16A
-
1
-
12
13
ISSUE 2013-08-06
Remark
Connect to starter coil directly
CAN
line(connect with controller's terminal
only)
Using impedance 120Ω connecting line
Using impedance 120Ω connecting line
Remark
ECU power
Configurable output 1,"ECU power"
Remark
CAN
line(connect with controller's terminal
only)
Using impedance 120Ω connecting line
Using impedance 120Ω connecting line
Remark
battery
Connect to starter coil directly
Connected to negative of battery
CAN
line(connect with controller's terminal
only)
Using impedance 120Ω connecting line
Using impedance 120Ω connecting line
Version 1.1
communication
communication
communication
Page 62 of 65
shielding
shielding
shielding
Advertisement
Table of Contents
