Maintenance; What You Have To Observe; Maintenance Schedule - Danfoss ET6200 Operator's Manual

6

Maintenance

6.1

What you have to observe

6.2

Maintenance schedule

Regular maintenance will ensure the continuous operation reliability
of the machine.
This Section describes action to be taken by you as the fitter regularly
to ensure the troublefree use of the machine.
•
Maintenance work may only be performed by qualified mainte-
nance staff (fitter).
•
Repair work on the machine or components may only be perfor-
med by appropriately qualified expert staff or UNIFLEX experts!
•
During all maintenance work, the machine must be disconnected
from the compressed air supply.
Machine out of service for mainte-
nance work!
Do not switch on!
•
Welding, flame-cutting and grinding work on and in the machine
and its environment must be approved in advance. There is a
risk of fire. The machine must be cleaned from dust and in-
flammable substances. Adequate ventilation must be ensured.
If not specified otherwise, inspections listed in the maintenance
schedule are visual inspection. Replace defective parts.
If you work in 2 shifts, the check frequency has to be doubled. If you
work in 3 shifts, you proceed as with 2-shift operation.
Record maintenance work performed in the maintenance log.