Completing The Installation - IBM EXP15 Hardware Maintenance Manual

4. Extend the rail outside of the rear rack mounting
flange; then, install and tighten both rear black hex
screws 1 .
5. Tighten the two front screws 2 ; then, tighten the
four large screws 3 .
Repeat step 2 on page 79 through step 5 to install
the rail marked R on the right side of the rack.
rules=nonewidth=col align='c c c' valign='t t t'.
Caution
Use safe practices when lifting.
6. Lift and then slide the expansion unit into the rack;
then, remove and discard both white screws and wing
nuts 1 from the bezel.
7. Align the bezel locator pins with the expansion unit;
then, secure the bezel and Netfinity FAStT EXP500
with two black hex screws 2 .
8. Use the two small screws 3 (removed in step 2 on
page 79) to secure the rear of the expansion unit.
9. Install hard disk drives, fans, ESM boards, and power
supplies in the EXP200 expansion unit according to
"Installing and replacing devices" on page 83; then,
return here to complete the installation.
10. Continue with "Completing the installation."

Completing the installation:

provides the information needed to complete the
installation. Instructions for installing the identification
labels and cabling the expansion unit are included.
80
IBM Netfinity EXP15, EXP200, EXP500 HMM
L
36.1 kg (79.5 lbs)
This section