Table of Contents
Advertisement
controller detects the data-transfer rate (10BASE-T, 100BASE-TX, or 1000BASE-T)
and duplex mode (full-duplex or half-duplex) of the network and automatically
operates at that rate and mode.
You do not have to set any jumpers or configure the controller. However, you must
install a device driver when you install a different operating system to enable the
operating system to address the controller. For device drivers and information about
configuring the Gigabit Ethernet controller, go to http://www.ibm.com/support/.
37
Chapter 4. Configuring the server
Advertisement
Table of Contents
