Table of Contents
Advertisement
Connecting the Power Supply
Connecting the car battery
When using this radio as a mobile unit, connect the DC power supply cable to the
negative ground 12 V car battery.
Cautions
z Use the radio in a car with a negative ground 12 V DC system, where the minus (-) pole of the
battery is connected to the car body.
z Do not connect the radio to the 24 V battery of a large vehicle.
z Do not use the cigarette lighter inside the car as a power source.
(1) Cable routing from inside the car to the engine compartment
Rout the DC power supply cable to the engine compartment, passing it through a
grommet in the fire wall from the passenger side.
1
Feed a hardened wire from the engine compartment through the grommet into the
interior of the car
2
Hook the end of the "feed" wire with the "bare wire" end of the provided DC power
supply cable
3
Fold and bend the ends of the wires and wind insulation tape around them
4
Pull the "feed" wire back into the engine compartment
The DC power supply cable will be pulled through the grommet into the engine
compartment.
5
Peel off the tape and remove the DC power supply cable from the "feed" wire
30
Hardened wire
かための針金
グロメッ ト
Grommet
②
Battery (12V)
バッテリー （12V）
➀Pass the cable through the grommet
①グロメッ トに貫通させる
Tape
テープ
DC power
supply cable
(accessory)
DC power
DC電源
supply
ケーブル
cable
Radio main
無線機本体
body
Advertisement
Table of Contents
