Table of Contents
Advertisement
14.7 Security > LAN>WAN
The LAN_WAN Configuration governs the outgoing data traffic, i.e. the following settings only apply to outgoing
data traffic.
Designation
Description
Enable
If the box has been checked, the following settings will be active after saving.
Action
The following options are available for selection:
Drop: If this option is selected, it means that no data packets can pass and the packets are delet-
ed immediately. The sender is not notified about the whereabouts of the data packets.
Reject: If this option is selected, the data packets are rejected. The sender is notified that the da-
ta packets have been rejected.
Accept: If this option is selected, the data packets can pass.
Source IP
Enter the IP of a computer from which data packets are sent to the Internet here.
If you leave the field blank, the set action applies to all IP addresses.
Source Port
Enter the port via which the data packets are sent into the Internet here.
Protocol
The following options are available for selection:
All: This setting applies to all protocols.
TCP: This setting only applies to the TCP protocol.
UDP: This setting only applies to the UDP protocol.
ICMP: This setting only applies to the ICMP protocol (ping).
WAN
This defines the WAN interface to which the setting is to be applied. You can select "Internet" or
interface
"WAN Ethernet".
Destination IP
Enter the Internet destination address of the data packets here.
Destination Port
Enter the port via which the data packets are sent to the destination IP here.
Accepts a new setting.
Edits the settings in the current line.
Deletes setting
Configuring Your Router in the Portal (V 1.x) | Page 117 of 131
Advertisement
Table of Contents
