Table of Contents
Advertisement
Available languages
Available languages
FIGURE 30
Sprocket
Spacer
Support Bracket
FIGURE 31
Reassemble new bonded friction wheel
•
rubber to the friction wheel assembly,
turn each screw approximately 2 turns
in order shown in Figure 30 until screws
are tight. It is important for the rubber
to be assembled symmetrically.
Position the friction wheel assembly up
•
onto the pin of the shift rod assembly
and slide the shaft through the friction
wheel. See Figure 31.
Slide the hex shaft into the hex I.D. of
•
the sprocket, the spacer and the left
ball bearing and secure with the
cupped washer and hex bolt.
Remove plastic film from gas cap.
•
NOTE: Make sure the pin from the
shift arm assembly is assembled to
the new friction wheel assembly.
CAUTION:
Check
snowthrower
nuts, bolts, etc. and keep these items
tightened.
Bonded friction
wheel rubber
Hex
self-tapping
screws
Shift Rod
Assembly
Friction
Pin
Wheel
Shaft
engine
frequently
for
STORAGE INSTRUCTIONS
NEVER STORE ENGINE WITH FUEL
IN
ENCLOSED, POORLY VENTILATED
ENCLOSURES, WHERE FUEL FUMES
MAY REACH AN OPEN FLAME OR
SPARK.
If unit is to be stored over 30 days, pre-
pare for storage as instructed in the
separate engine manual packed with
your unit.
NOTE: Failure to comply with sug-
gested
lubrication specifications will void
warranty.
and
loose
19
TANK
INDOORS
maintenance
OR
IN
and
Advertisement
Table of Contents
