Belt
Cover
Self-Tapping
Screw
Flat Washer
FIGURE 24
FIGURE 25
Auger
Idler
Rod
Ferrule
Brake
Bracket
Assembly
"Z"
Fitting
FIGURE 26
Remove the large shoulder bolt and
•
washer on the left hand side of the en-
gine pulley with an adjustable wrench.
See Figure 25.
Engine
Large
Pulley
Shoulder
Bolt
Cotter
Pin and
Washer
Cable Roller Guide
Assembly
FIGURE 27
NOTE: Reference to right hand or
left hand side of machine are ob-
served from the operating position.
Remove the cotter pin and washer from
•
the ferrule in order to disconnect the
auger idler rod from the brake bracket
assembly as shown in Figure 26.
Slip the auger drive belt (the front belt)
•
off the engine pulley. See Figure 28.
Pull the brake bracket assembly to-
•
wards the cable guide roller and
unhook the auger cable "Z" fitting. See
Figure 26.
Rem o ve
the
•
lockwashers which attach the auger
housing assembly to the frame assem-
bly. A 9/16" wrench is required. See
Figure 27.
Separate the auger housing from the
•
frame assembly by tilting the housing
forward and pulling up the handles.
Rest the handle assembly on the
•
ground and tip the remaining half for-
ward to rest on the housing.
To Remove the Auger Drive Belt:
a. Using a 9/16" wrench remove the five
belt keepers and lockwashers from
around the auger pulley. See Figure
28.
b. Remove and replace auger drive
belt.
c. Replace lockwashers and belt keep-
ers.
17
Frame
Remove
and Lock
Washer
to p
scr ew s
Auger
Housing
Screw
a nd