FIGURE 18
Slide Shoe
FIGURE 19
CHUTE CLEAN-OUT TOOL
The chute clean-out tool is conveniently
fastened to the rear of the auger hous-
ing with a mounting clip. Use the
clean-out tool to clear snow and ice
which may lodge in the discharge chute
during operation. Refer to the Operation
section for more detailed information re-
garding the chute clean-out tool.
BEFORE STARTING
NOTE: The crankcase has been
filled with oil and factory tested.
Paint on the muffler may have burnt
due to testing.
GAS AND OIL FILL-UP
Service the engine with gasoline and oil
as instructed in the separate engine
manual packed with your snowthrower.
Read instructions carefully.
Failure to follow this procedure may re-
sult in serious engine damage which
will not be covered by warranty.
Cable Control Wire
High
Middle
Low
Control positions and information mark-
ings,
on
international symbols, as explained.
Calls your attention to in-
structions concerning per-
sonal safety.
AUGER CLUTCH GRIP
Located on left hand handle.
Squeeze to engage. Release
to stop.
DRIVE CLUTCH GRIP
Located on right hand han-
dle. Squeeze to engage. Re-
lease to stop.
Shut off engine before un-
clogging discharge chute.
Avoid injury from rotating au-
ger – keep hands, feet and
clothing away.
Never put hand in chute.
Contact with rotating parts
can amputate fingers and
hands. Use clean-out tool to
unclog discharge chute.
Your unit may be equipped with a
plastic fuel plug at the opening of
the fuel tank. Please remove and
discard the plug before filling
your unit with gas or before
putting the unit into operation.
ATTENTION: YOU MUST CHECK OIL
LEVEL BEFORE OPERATION. LEVEL
MUST BE AT FULL MARK ON DIPSTICK
BEFORE ENGINE IS STARTED.
11
CONTROLS
your
machine
are
in