Table of Contents
Advertisement
9 TARGET COS PHI
By setting the target cos phi, the power factor to be
attained via the PF correction is defined.
Save and continue with ENTER.
10 TARGET 2nd cosPhi [ NO ]
1: NO
2: Timer
3: Energy supply (2nd target cos-phi - activated by
11 TARGET 2nd cosPhi
Set point for the 2nd target cosPhi
( only available if selected under 10 )
12 SWITCH ON TIME
Switch-on time of the timer for the 2nd target-cos phi
( only available if selected under 10 )
13 SWITCH OFF TIME
Switch-off time of the timer for the 2nd target-cos phi
( only available if selected under 10 )
14 MEASURING VOLTAGE
Programming of measuring voltage.
The values programmed here always refer to the
voltage at the clamps of the controller !
Selection via é / ê. Save / continue with ENTER
15 V-CONVERTER
When a measuring-voltage converter (e.g. for HV-
measurement) is used, its conversion ratio is to be
programmed here.
Selection via é / ê. Save / continue with ENTER
16 FREQUENCY
Input of the grid frequency of the measuring voltage
(needed for measuring system)
17 CONNECTING TIME: [ 1000 ] ms
The time between connecting the capacitors to increase
the momentary network capacitance. It should be noted
that in practical operation the real connection time is
affected by the discharge time (locking time).
Selection via é / ê. Save / continue with ENTER
=== PROGRAM-MODE ===
[ 0.98 ind ]
( 0.3 ind ... 0.3 cap )
( 1...3 )
( no 2nd target cosPhi,
continue with 14 )
( 2nd cos-phi - activated by timer,
scheduler with 12,13 )
energy-supply)
[ 0.9 IND ]
(0.3 ind ... 0.3 cap )
j
[ HH:MM:SS ]
2
j
2
[ HH:MM:SS ]
L-L [400]V
[ NO ]
(410V - 79kV / 400V )
[50] Hz
(50 / 60Hz)
(50...1000ms)
- 16 -
9
[ 0.98 IND]
10 TARGET 2nd cos j
[
12 SWITCH ON TIME j2
ON [16]: 00
OFF 07 : 00
( 50...760) V
15 V-CONVERTER
PRIMARY
[20000V] /
Prophi
15T-III
®
PROGRAM-MODE
TARGET cos j
PROGRAM-MODE
TIMER
]
PROGRAM-MODE
MO-FR
MO-FR
PROGRAM-MODE
SECONDARY
100V
17
Advertisement
Table of Contents
