Fronius GEN24 Operating Instructions Manual page 6

2
3
4
5
6
7
8
Ethernet:
1
2
3
4
5
6
7
6
Establish the connection to the inverter in the network settings (the inverter
is displayed with the name "FRONIUS_PILOT" and the serial number of the
device).
Password: enter 12345678 and confirm.
IMPORTANT!
To enter the password on a Windows 10 operating system, the link "Connect
using a security key instead" must first be activated to establish a connection
with the password: 12345678.
In the browser address bar, enter and confirm the IP address
192.168.250.181.
Select the "Technician" user in the "User menu" and enter and confirm the
password for the "Technician" user.
Call up the "Safety and grid regulations" → "Country setup" menu area.
Enter the requested access code (see chapter
input field "Access code country setup" and click the button "Activate".
Adjust the parameters in the individual menu areas taking into account the
nationally applicable standards and/or the specifications of the grid operator.
Establish a connection to the inverter (LAN1) with a network cable (CAT5
STP or higher).
Open the access point by touching the sensor once
flashes blue.
In the browser address bar, enter and confirm IP address 169.254.0.180.
Select the "Technician" user in the "User menu" and enter and confirm the
password for the "Technician" user.
Call up the "Safety and grid regulations" → "Country setup" menu area.
Enter the requested access code (see chapter
input field "Access code country setup" and click the button "Activate".
Adjust the parameters in the individual menu areas taking into account the
nationally applicable standards and/or the specifications of the grid operator.
1
open access point
Access code on page 4) in the
169.254.0.180
2
→ Communication LED:
Access code on page 4) in the