Table 80 Fru Cable Table Reference - Oracle Pillar Axiom Service Manual

Appendix C Introduction to Private Management Network and SSF Cable Tables
Important! Dress all network cables along the right side of
the rack (when viewed from the rear). Dress them in a way
that would not result in them needing to be disconnected
when another FRU needs to be replaced.
The lengths of Fibre Channel cables are as follows:
Use the following table to determine the cable tables to which
you should refer when you recable a FRU.

Table 80 FRU cable table reference

To recable For a 1-Slammer system,
this FRU ... refer to...
Pilot CU • Table 81,
• Table 82,
Pillar Data Systems Confidential
• CU cross-connections within a Slammer: 1.6 ft (0.5 m).
• From a Slammer to a Brick: 6.6 ft (2 m).
• Between Bricks: 1.6 ft (0.5 m) or 6.6 ft (2 m).
Note: If the system shipped from Pillar Data Systems
with Brick 5 and Brick 9 or Brick 6 and Brick 10 pre-
installed, the cables are 1.6 ft (0.5 m). Otherwise, these
cables are 6.6 ft (2 m) too.
• CU cross-connections within a Brick: 1.6 ft (0.5 m).
Pilot CU0 in a 1-
Slammer system
Pilot CU1 in a 1-
Slammer system
For a 2-Slammer system,
refer to...
• Table 83, Pilot CU0 in a 2-
Slammer system
• Table 84, Pilot CU1 in a 2-
Slammer system
214