Figure 28: Installing The Cage Nuts; Figure 29: Attaching The Rails To The Rack - HPE StoreFabric M-Series Hardware User Manual

three holes, the cage nut should be installed vertically with its ears engaging the top and bot-
tom holes only. See
While your installation partner is supporting the system's weight, perform steps 3, 4 and 5:
On the rear side of the cabinet, install the two blades (B) in the selected rack unit, using four
Step 3.
M6 screws (C). Do not tighten the screws yet. See
Slide the two blades into the left and right rails, and adjust them to fit your rack's depth. Use
Step 4.
four M6 screws (D) to fix the blades into the rack. Do not tighten the screws yet. See
Figure
32
Figure 28.

Figure 28: Installing the Cage Nuts

Figure 29: Attaching the Rails to the Rack

30.
Figure 29.
User Manual