Table of Contents
Advertisement
Section 2
DESCRIPTION
Figure 2-6 Supervisor II Panel
plays to change displays and in parameter
setup mode to increment a value. When in
the default display the key will light all the
lamps for three seconds.
2.10 STATUS DISPLAYS
By default the line pressure (P2) and discharge
temperature (T1) are shown on the bottom line of
the display, and machine status on the top line.
The following are the various machine status mes-
sages that indicate the state of the compressor:
(Display graphics shown below.)
• STOP - Compressor is off.
• STANDBY - Compressor is off but armed to
start. This state may be entered because of
a power up, or the unload timer had expired
and stopped the machine.
20
The machine may start at any time.
• STARTING - Machine is trying to start.
• OFF LOAD - Machine is running and off
loaded.
• ON LOAD - Machine is running and loaded.
• FULL LD - Machine is running and fully
loaded. This state is only displayed if the
machine has a full load valve.
• RMT STOP - Compressor is off but armed to
start. The machine will start when the
remote start contact is closed.
The machine may start at any time.
• SEQ STOP - Compressor is off but armed to
start. The machine will start when the
Advertisement
Table of Contents
