Motorola AltiVec MVME5100 Series Installation & Use Manual page 42

Primary SCSI Data Bus Width [W/N] = N?
Secondary SCSI identifier = 07?
Select the identifier. (Default = 07.)
NVRAM Bootlist (GEV.fw-boot-path) Boot Enable [Y/N] = N?
Note
NVRAM Bootlist (GEV.fw-boot-path) Boot at power-up only [Y/N] = N?
NVRAM Bootlist (GEV.fw-boot-path) Boot Abort Delay = 5?
The time (in seconds) that a boot from the NVRAM boot list will delay
before starting the boot. The purpose for the delay is to allow you the
option of stopping the boot by use of the
is from 0-255 seconds. (Default = 5 seconds)
Auto Boot Enable [Y/N]
Auto Boot at powerup only [Y/N] = N?
http://www.motorola.com/computer/literature
Wide SCSI (16-bit bus).
W
Narrow SCSI (8-bit bus). (Default)
N
Y Give boot priority to devices defined in the fw-boot-
path global environment variable (GEV).
Do not give boot priority to devices listed in the fw-
N
boot-path GEV. (Default)
When enabled, the GEV boot takes priority over all other
boots, including Autoboot and Network Boot.
Give boot priority to devices defined in the fw-boot-
Y
path GEV at powerup reset only.
Give powerup boot priority to devices listed in the fw-
N
boot-path GEV at any reset. (Default)
= N?
The Autoboot function is enabled.
Y
The Autoboot function is disabled. (Default)
N
Autoboot is attempted at powerup reset only.
Y
Autoboot is attempted at any reset. (Default)
N
Default Settings
key. The time value
BREAK
3
3-11