Motorola AltiVec MVME5100 Series Installation & Use Manual page 41

PPCBug Firmware
3
3-10
Auto-Initialize of NVRAM Header Enable [Y/N] = Y?
Y
N
Network PReP-Boot Mode Enable [Y/N] = N?
Y
N
Negate VMEbus SYSFAIL* Always [Y/N] = N?
Y
N
SCSI Bus Reset on Debugger Startup [Y/N] = N?
Y
N
Primary SCSI Bus Negotiations Type [A/S/N] = A?
A
S
N
NVRAM (PReP partition) header space will be
initialized automatically during board initialization,
but only if the PReP partition fails a sanity check.
(Default)
NVRAM header space will not be initialized
automatically during board initialization.
Enable PReP-style network booting (same boot image
from a network interface as from a mass storage
device).
Do not enable PReP-style network booting. (Default)
Negate the VMEbus SYSFAIL
initialization.
Negate the VMEbus SYSFAIL
successful completion or entrance into the bug
command monitor. (Default)
Local SCSI bus is reset on debugger setup.
Local SCSI bus is not reset on debugger setup.
(Default)
Asynchronous SCSI bus negotiation. (Default)
Synchronous SCSI bus negotiation.
None.
Computer Group Literature Center Web Site
∗
signal during board
∗
signal after