Primary Pmcspan - Motorola AltiVec MVME5100 Series Installation & Use Manual

Hardware Preparation and Installation
1

Primary PMCspan

Warning
Caution
1-8
To install a PMCspan-002 PCI expansion module on your MVME5100,
perform the following steps while referring to the figure on the next page:
Dangerous voltages, capable of causing death, are present in
this equipment. Use extreme caution when handling, testing,
and adjusting.
1. Inserting or removing modules with power applied may
result in damage to module components.
2. Avoid touching areas of integrated circuitry, static discharge can
damage these circuits.
Note
This procedure assumes that you have read the user's manual that
was furnished with your PMCspan and that you have installed the
selected PMC modules on to your PMCspan according to the
instructions provided in the PMCspan and PMC manuals.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to an electrical ground. Note that the system chassis may not
be grounded if it is unplugged. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VME modules.
3. If the MVME5100 has already been installed in a VMEbus card slot,
carefully remove it as shown in
connectors P1and P2 facing you.
4. Attach the four standoffs to the MVME5100. For each standoff:
– Insert the threaded end into the standoff hole at each corner of
the MVME5100.
– Thread the locking nuts into the standoff tips and tighten.
5. Place the PMCspan on top of the MVME5100. Align the mounting
holes in each corner to the standoffs and align PMCspan connector
P4 with MVME5100 connector J25.
Figure 1-2 and place it with
Computer Group Literature Center Web Site