universalblue Campana T 60 Instruction Manual page 35

REPLACING THE BULB
The bulb must be replaced by the manufacturer, its service agent or
similarly qualified person.
Always switch off the electricity supply before carrying out any
operations on the appliance. When handling bulb, make sure it is
completely cool down before any direct contact to hands.
To replace the bulb, please consider the following instructions:
 Remove the grease filter.

Find the junction box, unscrew the screws from the cover of
the junction box, then remove the cover from the junction box
(if there is a wire pressure plate that pressed the light wire,
the wire pressure plate must be removed first). See photo 1.
The connection box can vary from one model to another (Box
A or B of the drawing below)
 Find the terminal of the light connection cable and remove it.
See photo 2.
o Option 1: Use a tool or hand to press the spring
splinter from both sides of the LED light inward, until
the light goes out, (image 3). Then, slightly pull out the
light connection cable, (image 4).
o Option 2. Use a straight screwdriver to lift the lower
edge of the LED light (photo 5), then slightly pull out
the light connection cable, (photo 4).
 Apply the reverse procedure to reinstall the light
35