universalblue Campana T 60 Instruction Manual page 32

CARBON FILTERS INSTALLATION
CARBON FILTERS ARE NOT INCLUDED WITH THIS
APPLIANCE
Carbon filters can be installed to clean the air by trapping odors on a
porous surface (it absorbs grease, steam and odors), so it filters the
dirty air and returns it to the renovated air. Carbon filters can be
used for a shot time and usually must be changed after three or six
months according to your cooking habit. The procedure for
installing the activated carbon filter is as follows.
 Put the pin of the carbon filter into the rectangular hole of the
fan(as per the arrow A shown below)
 Push the other side of the carbon filter toward the fan to
make it flat(as per the arrow B shown),and then press filter
into fan.
 If you want to remove the filter, press fastener of filter and
remove it by turning anticlockwise.
Make sure the filter is tightly closed. Otherwise, it would
loosen and cause danger. When the activated carbon filter is
connected, the suction power will be reduced.
32