universalblue Campana T 60 Instruction Manual page 31

 Do not reduce the size or restrict expansion pipe.
 When using expansion pipe always install the pipe pulled taut
to minimize pressure loss.
 Failure to observe these basic instructions will reduce the
performance and increase noise levels of the cooker hood.
 Any installation work must be carried out by a qualified
electrician or competent person.
 Do not connect the ducting system of the hood to any
existing ventilation system which is being used for any other
appliance ,such as warmer tube, gas tube , hot wind tube.
 The angle of the bend of the expansion pipe should not be
less than 120º; you must direct the pipe horizontally, or,
alternatively, the pipe should go up from the initial point and
should be led to an outer wall.
 After installation ,make sure that the cooker hood is level to
avoid grease collection at on end.
 Ensure the expansion pipe selected for installation complies
with relevant standards and is fire retardant.
For safety reasons, use only the same mounting size or
mounting screw recommended in this instruction manual.
If the screws or fastening device are not installed in
accordance with these instructions, electrical hazards may
occur.
31