Table of Contents
Advertisement
EWL 70, 120.
Cut approx. 6 x 6 mm out of the rinsing
panel bead at the front on the left-hand side
for the connecting cable.
Slide the fume cupboard by its guide rails
over the rinsing panel edge, and push back
to the wall.
Lift the acid cabinet lightly at the
points of cable entry because the rear
wall is slightly lower. To avoid squeezing
the cable place it in the recess at the front
on the left-hand side.
A 5.3 Fitting the water inlet
Insert the inlet tube @ with washer " in
the rinsing panel screw together tightly
with nut # and washer ".
Apply sealing compound to the thread of
the inlet tube, and screw on the inlet stop-
cock £. The handwheel should be facing
forwards.
The plastic thread damages easily.
Do not use a sealing compound that
is aggressive towards plastics.
The link with the customer's water supply
connection must be completed and checked
by an authorized specialist.
6
1
2
2
3
4
Advertisement
Table of Contents
