Kyocera EcoPro EP C170N User Manual page 52

Using the Operator Panel
2-26
6 Press or
Copy appears.
7 Press [OK] ([ENTER]). A blinking cursor (_)
appears.
8 Press or to increase or decrease the value at the blinking cursor. The
value can be set between 0 and 50. Use
and left.
9
When the desired maximum number of jobs is set, press [OK] ([ENTER]).
10
Press [MENU]. The display returns to Ready.
Maximum Space Assigned to Temporary Code Jobs
This changes the hard disk space that holds temporary code jobs. You can
change the maximum space from 0 to 9999 (megabytes). The actual
maximum size depends on the size of free hard disk space. The default
size is 1/6 of the total hard disk space, rounded off in units of 50MB. For
example, if the total hard disk space is 10GB, the default size is 1550MB.
1 Press [MENU].
2
Press or
appears.
3
Press .
4
Press or
Configuration > appears.
5
Press .
6
Press or
Code JOB Size appears.
7
To change the maximum disk space, press
[OK] ([ENTER]). A blinking cursor (_)
appears.
8
Press or
blinking cursor. Use
repeatedly until >>Quick
repeatedly until e-MPS >
repeatedly until >e-MPS
repeatedly until >>Temp.
to increase or decrease, respectively, the value at the
and to move the cursor right and left.
>>Quick Copy
>>Quick Copy
and to move the cursor right
e-MPS
>e-MPS
Configuration
>>Temp. Code JOB
Size
>>Temp. Code JOB
Size
ADVANCED OPERATION GUIDE
32
32
>
>
1550MB
1550MB