Test Running - HNC Electric HV590 Series User Manual

Motor 3
Motor 4
If motor and the load can not be totally separated, please select P1.37(Motor 2\3\4 as
A2\A3\A4.37) to 1(Asynchronous machine static tuning), then press RUN key on keyboard panel.

4.4 Test running

HV590 General machine type factory setting value
Code
P0.01
P0.02
P0.03
Users set motor parameters P1.00~P1.05 to correct values, after parameters auto tuning,
motor operation can be directly controlled through keyboard, while frequency can be set through
keyboard potentiometer.
Section IV. Keyboard Operation
A2.08： Asynchronous motor leakage inductance
A2.09： Asynchronous motor mutual inductance
P2.10： Asynchronous motor no-load current
A3.06： Asynchronous motor stator resistance
A3.07： Asynchronous motor rotor resistance
A3.08： Asynchronous motor leakage inductance
A3.09： Asynchronous motor mutual inductance
P3.10： Asynchronous motor no-load current
A4.06： Asynchronous motor stator resistance
A4.07： Asynchronous motor rotor resistance
A4.08： Asynchronous motor leakage inductance
A4.09： Asynchronous motor mutual inductance
P4.10： Asynchronous motor no-load current
Factory setting
0
0
4
Table4-3.5
Description
Speed sensorless vector control (SVC)
Operation panel command channel(LED OFF)
AI3(Potentiometer)
36