Motor Parameter Automatic Tuning - HNC Electric HV590 Series User Manual

4.3.6 Motor parameter automatic tuning

Vector control running mode：before running, user must accurately input motor nameplate
parameters. HV590 series inverter will be matching standard motor parameter according to this
nameplate. Vector control methods are very much dependent on motor parameters, to get good
control performance, accurate control motor parameters must be acquired.
Motor parameter auto tuning procedure is as follows：
Firstly, select command source(P0.02) as operation panel command channel.Secondly,
input parameters below in accordance with motor actual parameter：
Motor selection
Motor 1
Motor 2
Motor 3
Motor 4
E.g：Asynchronous motor parameter tuning
If motor and the load can be totally separated, please select P1.37(Motor 2\3\4 as
A2\A3\A4.37) to 2(Asynchronous machine complete tuning), then press RUN key on keyboard
panel, inverter will automatically calculate the motor of the following parameters：
Motor selection
Motor 1
Motor 2
Section IV. Keyboard Operation
P1.00：Motor type selection
P1.02：Motor rated voltage
P1.04：Motor rated frequency
A2.00：Motor type selection
A2.02：Motor rated voltage
A2.04：Motor rated frequency
A3.00：Motor type selection
A3.02：Motor rated voltage
A3.04：Motor rated frequency
A4.00：Motor type selection
A4.02：Motor rated voltage
A4.04：Motor rated frequency
Parameter
P1.06：Asynchronous motor stator resistance
P1.07： Asynchronous motor rotor resistance
P1.08： Asynchronous motor leakage inductance
P1.09： Asynchronous motor mutual inductance
P1.10： Asynchronous motor no-load current
A2.06： Asynchronous motor stator resistance
A2.07： Asynchronous motor rotor resistance
Parameter
P1.01：Motor rated power
P1.03：Motor rated current
P1.05：Motor rated revolving speed
A2.01：Motor rated power
A2.03：Motor rated current
A2.05：Motor rated revolving speed
A3.01：Motor rated power
A3.03：Motor rated current
A3.05：Motor rated revolving speed
A4.01：Motor rated power
A4.03：Motor rated current
A4.05：Motor rated revolving speed
Table 4-3.4
35