User Set Parameter Operation Mode - HNC Electric HV590 Series User Manual

Relevant function parameters PP.02、PP.03
Parameters display mode
attributes
PP.02
Set range
Individual parameter mode
display selection
PP.03
Set range
When there is 1bit display existing in the individual parameter mode display selection(PP.03),
you can enter different parameter display mode by pressing PRG+>>/SHIFT key at the same time.
Each parameter display codes：
Function parameter mode-FunC
User set parameter mode -USEt
User modify parameter mode -U--C
Switching mode as below：
E.g：To switch current function parameter mode to user set parameter mode.

4.3.3 User set parameter operation mode

User set menu is established for quick checkup and modification. The display mode is
"uP3.02",which represents function parameter P3.02. It has the same effect of modifying
parameter in user set menu and normal programming state.
Function parameters of user set menu come from PE group.PE group chooses function
Section IV. Keyboard Operation
1bit U group display selection
0 No display
1 Display
10bit A group display selecton
0 No display
1 Display
1bit User set parameter display selection
0 No display
1 Display
10bit User modify parameter display selection
0 No display
1 Display
Table 4-3.2
Parameter display mode
Table 4-3.3
PRG+>>SHIFT
Fig. 4-3.3
set as below：
,
Default
value
Default
value
33
11
00
Display
ENTER