Ar-Ef1 / Ar-Rk1 - Sharp AR-M350U Service Manual

E. Setting related to fusing
1) Put down the right and the left levers of the fusing unit in the arrow
direction.
F. Paper setting
1) Pull out the first stage paper feed tray.
Slowly pull out the tray until it stops.
2) While pressing the paper holding plate, remove the fixing pin.
3) Put paper in the tray, and close the paper feed tray.

5. AR-EF1 / AR-RK1

<Before installation>
•For installation, an MFP control board (AR-M11) is needed.
Parts included for the rack
1) Assemble the rack.
Insert two racks A securely all the way into two racks B respectively
as shown in the illustration and use four screws (M4 x 8) respectively
to secure the racks in the order of <1> to <2> in the illustration.
2) Cut the rear cabinet of the desk unit.
Cut the cut-off portions on both ends of the rear cabinet of the desk
unit by hand and remove them.
AR-M350 UNPACKING AND INSTALLATION 6-6
Racks A
Shaft
(2 pcs.)
(1 pc.)
Cam A
Screws (M4 x 8)
(1 pc.)
(8 pcs.)
Racks B Cam B Screws (M3 x 6)
(2 pcs.) (1 pc.)
(2 pcs.)
2
1
Screws
1
M4 x 8
Racks B
Cut-off portions
Parts included in
the scanner unit
Cam A securing screw
(M3 x 12) (1 pc.)
Tray
(1 pc.)
M4 stepped screws
(3 pcs.)
Rack sheet: 1 sheet
Screws (M5 x 70)
(4 pcs.)
Racks A
2
Screws
M4 x 8