Updating Parameters; Function Block Application - Thermo Scientific LevelPRO Series Application Manual

Parameters Parameters
Function Block Function Block
Application Application
Thermo Fisher Scientific
After saving, the asterisk that appeared by the modified parameter will
clear, indicating that the changes have been accepted.
Note If you do not want to save the changes you made, you can undo
them by clicking the Read All button at the bottom of the configuration
window. This causes a read of the parameter values stored in the device
(before the changes).
Updating ating
There are several ways to update the parameter values:
●
●
●
Typically, once you have configured block parameters, you can create a
block diagram (or control strategy). Following is an example of how to
create a basic connection to the AI block using the Function Block
Application (FBAP).
1. Double-click the Function Block Application object in the
configuration tree. The FBAP grid opens in the middle frame.
2. For this example, connect the AO block of another device on the
network to the LevelPRO AI block. Click on the LevelPRO AI block
and drag it to the FBAP grid.
▲
To update all parameters in the block configuration window you
have open, click the Read All/Set Defaults icon in the toolbar.
(This may also be accomplished by clicking the Read All button at
the bottom of the window.)
To update a single parameter, click on it and then click the Read
Selected/Set Selected Default icon.
To update all parameters in the block configuration window
automatically, click the Periodic Updates box and select a poll rate.
LevelPRO with F
The NI-FBUS Configurator
Configurator Basics
™ fieldbus Application Guide
OUNDATION
3-13