Flowchart - Siemens LITHOSTAR Multiline SP Start-Up Instructions

6 - 2

Flowchart

NOTE
Open start-up protocol with Manager →Open new protocol
(Menu option § 16 X-Ray Ordinance is presently not used)
LITHOSTAR Multiline
System manual
The IQC program and IQC data disks are located in the in the sys-
tem binder. Instructions can be taken from the IQC program
instructions RXD0-000.073.... The installation text appears in Ger-
man, however other languages can be set.
The following flowchart displays only the basic steps of the IQ
tests.
Is the IQC Program
installed on the service PC?
yes
Start IQC Program
Load data from the system disk with
Copy data → Load data from file...→ALL
no
and confirm with Yes
Select IQ start-up and confirm query "DHHS" or
continue with ESC
Checking the Dose Rate
yes
Loaded
protocol
"open"
"NO"
RXL2-120.815.01
Rev. 02 02.05
no
Refer to instructions IQC-
Program RXD0-000.073
Install the program on the
DOS level.
Close protocol with
Manager → close
protocol
Page 2 of 18
CS PS 24
6
...
Siemens AG
Medical Solutions