Alkaline Battery Pack; To Replace The Batteries; Changing Instrument Settings - MSA Orion Operation Manual

Chapter 4, Setting up the Multigas Detector
• See TABLE 4-3 for batteries approved for use in the Orion

alkaline battery pack.

Table 4-3. Batteries Approved for use in the Orion
BATTERY
DURACELL MN1500
VARTA 4006
Energizer E91

To Replace the Batteries

1. Remove battery pack from the instrument by removing the two
screws located in the bottom corners of the battery pack.
2. Gently lift the pack out of its recess and pull it out.
3. Loosen the single screw that holds the plastic battery cover to
the battery pack using the supplied hex key.
4. Remove the plastic cover, exposing the replaceable batteries.
5. Remove the depleted batteries.
NOTE: Follow local regulations regarding battery disposal.
6. Install the new batteries, observing the direction of the positive
(+) battery terminal. The instrument will not operate if any or
all cells are reversed.
7. Replace the plastic battery cover and tighten the screw.
8. Re-install the battery pack on the instrument.

Changing Instrument Settings

• Many of the Orion Multigas Detector options can be set using
the two buttons on the front of the instrument.
• If the Orion Multigas Detector was ordered with the optional
datalogging, the MSA FiveStar LINK software can be used to
set most of the instrument selections, including some that
cannot be changed from the instrument's front panel buttons.
• See TABLE 4-4 for available selections and methods for
changing those selections.
4-4
Alkaline Battery Pack
UL/C-UL EUROPE
•
•
•
Operating Manual
AUSTRALIA
• •
•
• •