Connecting Cables - Epson OP1 Safety And Installation

2.4 Connecting Cables

Be sure to connect the cables between the Controller and the Operator
Panel properly. Do not allow unnecessary strain on the cables. (Do not
put heavy objects on the cables. Do not bend or pull the cables forcibly.)
The unnecessary strain on the cables may result in damage to the
cables, disconnection, and/or contact failure.
WARNING
disconnection, or contact failure is extremely hazardous and may result
in electric shock and/or improper function of the system. Do not use the
cables near heat or fire.
Be sure to turn OFF the Controller before connecting and disconnecting
cables. Connecting or disconnecting the cables with the power ON may
result in malfunction of the robot system.
CAUTION
(1) Turn OFF the Controller.
(2) Disconnect the bypass plug from the Controller.
(3) Connect the right angle connector
of the OP1 cable to the Controller,
and secure it with hexagon head
screws.
(4) Connect the straight connector to
the Controller connector of the
Operator Panel, and secure it with
fitting screws.
OP1 Safety and Installation Rev.3
2. Installation
Damaged cables,
15