Epson OP1 Safety And Installation page 11

Immediately press the EMERGENCY STOP switch whenever you
suspect any danger.
The Operator Panel is equipped with an EMERGENCY STOP switch.
Before operating the Operator Panel, make sure that the
EMERGENCY STOP switch on the Operator Panel functions properly.
Operating the Operator Panel when the switch does not function
WARING
properly is extremely hazardous and may result in serious bodily injury
and/or serious damage to the equipment, as the switch cannot fulfill its
intended function in an emergency.
Be sure to connect the cables between the Controller and the Operator
Panel properly. Do not allow unnecessary strain on the cables. (Do not
put heavy objects on the cables. Do not bend or pull the cables forcibly.)
The unnecessary strain on the cables may result in damage to the
cables, disconnection, and/or contact failure.
WARNING
disconnection, or contact failure is extremely hazardous and may result
in electric shock and/or improper function of the system. Do not use the
cables near heat or fire.
Do not shock the Operator Panel physically or place any object on
Operator Panel. A liquid crystal display is used for the Operator Panel
display. If the display is damaged, liquid crystal may leak out. Liquid
crystal is harmful. If it sticks on your skin or clothes, immediately wash
your skin and clothes thoroughly with clean water and soap
immediately.
The Operator Panel must be used within the environmental conditions
CAUTION
described in this manual.
manufactured strictly for use in a normal indoor environment. Using
this product in the environment that exceeds the conditions may not
only shorten the life cycle of the product but also cause serious safety
problems.
OP1 Safety and Installation Rev.3
This product has been designed and
1. Safety
Damaged cables,
3