Table of Contents
Advertisement
Stratasys J826
Accessories and Utilities
Start-Up Kit
The printer is supplied with a start-up kit, which includes tools and accessories. These tools and
accessories should be available during printer installation and operation.
Exhaust Adapter
An exhaust adapter is supplied with the printer. When attached to the back of the printer and connected to
an external ventilation fan with a duct, air expelled from the printer is discharged directly outdoors, as
shown in the figure below.
It is recommended to install an eyewash station near the printer, for emergency use.
©
DOC-18005 Rev. E
Duct Diameter Minimum
4 in (100 mm)
106 cfm (3 m
Figure 7 Printer exhaust system
2019-2020 Stratasys. All rights reserved.
Required Suction at the Exhaust Adapter
Maximum
3
/min) 134 cfm (3.8 m
Accessories and Utilities
3
/min)
17
Advertisement
Table of Contents
