To Inspect The Probe - Agilent Technologies 54701A User's And Service Manual

Introduction
This chapter shows you how to connect and operate the 54701A Active Probe.
The following information is covered in this chapter:
• Inspection
• Probe operating range
• Connecting the probe
• Operating the probe with oscilloscope power
• Operating the probe with a power module
• Using accessories

To inspect the probe

❏ Inspect the shipping container for damage.
Keep a damaged shipping container or cushioning material until the
contents of the shipment have been checked for completeness and the
instrument has been checked mechanically and electrically.
❏ Check the accessories.
Accessories supplied with the instrument are listed in "Accessories
Supplied" in table 1, page 16 in this manual.
• If the contents are incomplete or damaged notify your Agilent
Technologies sales office.
❏ Inspect the instrument.
• If there is mechanical damage or defect, or if the instrument does not
operate properly or pass calibration tests, notify your Agilent
Technologies sales office.
• If the shipping container is damaged, or the cushioning materials show
signs of stress, notify the carrier as well as your Agilent Technologies
sales office. Keep the shipping materials for the carrier's inspection.
The Agilent office will arrange for repair or replacement at Agilent
Technologies' option without waiting for claim settlement.
Chapter 1: Operating the Probe
9