Iar Project; Jumper Settings; Boards Supported; Serial I/O - ST SimpleMAC STM32W108 Series User Manual

UM0893
4.5.1

IAR project

Follow these steps to use the project with the IAR Embedded Workbench for ARM:
1. Open the IAR Embedded Workbench for ARM.
From the File > Open > Workspace menu, open the related IAR workspace.
2.
3. Select the configuration you want to build.
Select Project > Rebuild All. This will recompile and link the entire application.
4.
5. To launch a debug session, connect the IAR Jlink to the JTAG connector (P1) on the
board.
Select Project > Download and Debug. The related binary image is downloaded into
6.
the STM32W108CC Flash memory, and the interactive debug session is started.
7. Connect the application board to a PC USB port. Open a hyperterminal on the
corresponding USB virtual COMx port with the configuration as described in
Section 4.5.4: Serial
4.5.2

Jumper settings

Table 23.
4.5.3

Boards supported

Table 24.
Board name
Primer2 + MB850 A
MB851
MB954
MB950A + MB953
MB951
X = supported
- = not supported
NA = not applicable
4.5.4

Serial I/O

The application listens for commands sent over the serial port with the following settings:
I/O.
Jumper settings
Jumper name
JP1, if available
P1, if available
Boards supported
Board revision
A
A,B,C
D
A,B
C
MB953A
MB953B
A
B
Doc ID 16995 Rev 10
STM32W108 SimpleMAC demonstration applications
STM32W108xB
X
X
NA
X
NA
X
NA
X
NA
STM32W108xB
Irrelevant
5-6
STM32W108CC ota_bootloader
NA
NA
X
NA
X
NA
X
NA
X
-
X
X
X
X
X
X
X
X
35/54