Advertisement
HS4100-EVK Evaluation Kit Manual
1.2
Kit Hardware Connections
Complete the following procedure to set up the kit as shown in Figure 3:
1. Install the software from the USB flash drive or download from renesas.com as described in Software
Installation and Setup.
2. Connect one of the HS4101 sensor modules facing up, with or without the extension cable attached, into the
sensor module connector
3. Connect the USB port
3
LED
will light up. The sensor will now be active and the analog RH and Temperature voltages can be
measured using the on-board test point
4. Run the Demo Software package from the Start menu, and click on the "Measure" button
data will be displayed on the graph
R36UH0008EU0100 Rev.1.00
Jun 16, 2022
1
.
2
of the board to the user's computer using the supplied USB cable. The power
4
.
6
.
Figure 3. Evaluation Kit Connections
Figure 4. Start Measurements
5
. The captured
Page 4
Advertisement
