SDAH01 Evaluation Kit Manual
1.2
Kit Hardware Connections
Complete the following procedure to set up the kit as shown in Figure 3:
1. Install the software from the USB flash drive or download from renesas.com as described in Software
Installation and Setup.
2. Connect one of the HS3001 sensor modules facing up, with or without the extension cable attached, into the
sensor module connector
3. Connect the USB port
the power switch
3
4. Run the Demo Software package from the Start menu, and click on the "Measure" button
"Measuring" indicator
R36UH0004EU0100 Rev.1.00
Aug 27, 2021
.
1
of the board to the user's computer using the supplied USB cable, and ensure that
2
on the board is in the USB position. The "USB" LED
will blink whenever data is being captured.
6
Figure 3. Evaluation Kit Connections
Figure 4. Start Measurements
will light.
4
. The
5
Page 4