Christie CP2220 Installation And Setup Manual page 14

2. Remove the two horizontal supports from each side of the rack.
a) Remove the two screws from each end of the horizontal support.
b) Set the horizontal support aside.
c) For the remaining three horizontal supports, repeat steps a and b.
3. Install one vertical support on each side of the rack using two screws, two lock washers, and
two washers in each of the four mounting holes.
As illustrated, make sure both vertical supports are installed using the front or using the back
side-mounting holes. Vertical support placement determines whether components are installed
at the front or the back side-mounting location.
Christie Rack Mount Pedestal Installation and Setup Guide
020-100632-04 Rev. 1 (08-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
14