Installing The Projector Foot Locks; Configuring The Rack For Side-Mounting - Christie CP2220 Installation And Setup Manual

7. Make sure enough space is provided between the projector and the foot brackets.
This space is required to install the projector foot bracket locks.

Installing the projector foot locks

The foot locks secure the projector feet into position.
1. Slide the projector foot lock over the projector foot bracket.
2. Install one screw in each of the four projector foot locks to secure them in position.

Configuring the rack for side-mounting

By default, the Christie Rack Mount Pedestal is configured for back-mounting of components. Complete
this procedure if side-mounting of components is required.
1. Remove the side panel from each side of the rack.
a) Unlock the side panel.
b) Press down on the two panel latches and tip the panel away from the rack.
c) Lift the panel up and out from the rack and set aside.
d) For the second panel, repeat steps a to c.
Christie Rack Mount Pedestal Installation and Setup Guide
020-100632-04 Rev. 1 (08-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
13